Quote Originally Posted by bee utey View Post
One shouldn't have to remove the fittings. Just undo the clamping nuts and lower the cradle an inch or two at a time using blocks of wood or a big trolley jack. The tanks should rotate to near vertical orientation in the cradle with a bit of an occasional boof from a lump of wood from outside the chassis rails.
Nup! mine wouldn't come out, whether an inch or two was used, or a mallet or 3 was used.
Just wouldn't come down between chassis rails whichever way I tried.

So had to remove one tanks fittings. Not easily accessible, but accessible through the chassis curve, and from then on easy(too easy, as I found out).