Thread: Lots of Questions

Thanks again. Are there not any accumulators available in Australia? Or are they too expensive here? How long should the ABS pump run upon start up. I read somewhere that this can be the clue to identifying a faulty accumulator?
I don't know if anyone has done it before but I just replaced the buttons on both my key remotes with silicone ones. Thought I did well paying $32 for both remotes and they are easy to fit, brings the remotes back to almost new!
I am also in need of an air filter cover, my original is broken as a result of a backfire which must have happened before I bought the vehicle. Any ideas where I may get one?
Thanks guys.

Originally Posted by Stuart555

I don't know if anyone has done it before but I just replaced the buttons on both my key remotes with silicone ones. Thought I did well paying $32 for both remotes and they are easy to fit, brings the remotes back to almost new!

Genuines are available from Land Rover for about $5 each .

Originally Posted by Stuart555

Thanks again. Are there not any accumulators available in Australia? Or are they too expensive here? How long should the ABS pump run upon start up. I read somewhere that this can be the clue to identifying a faulty accumulator?

They're readily available but are quite expensive out here, even from a non- LR dealer.
Usually, the first symptom of the accumulator getting weak is the hard brake pedal first thing in the morning. If this is the case, let the pump run for 15-30sec & it will build up pressure for braking.

Originally Posted by Scouse

Genuines are available from Land Rover for about $5 each .

Gee thanks......just what i wanted to hear. Hopefully these silicone ones will last a lot longer than the crappy rubber ones

Originally Posted by Stuart555

Gee thanks.

No problem .

The LR ones only last about 3 years in my experience so hopefully the silicone jobbies last longer.

My genuine LR ones only lasted a bit over 2 years.

I bought the silicon ones and they seem to be doing alright.

Main thing is, if they wear out don't wait too long to replace them.

Dave

Hello guys.....I am back. In an earlier post I spoke about my heater not working on the left side and that I thought it was a blend motor gone wrong, well I think it is still that but now the readout on the HEVAC is faulty sometimes, sometimes not, and I was just wondering if this could be related to the heater problems? Another thing I was wondering, has anyone had cause to repair the rear window demister? I have a couple of bars not working but I can't find any breaks using visual and multimeter methods. Any suggestions? Thanks.

If you mean the LCD display is playing up and intermittently displaying incomplete numbers etc, then this is quite common and unlikely related to the heating issues which is most likely the blend motors.

I live in Brisbane and would not have a clue if my demister works or not.

I'll assume it doesn't.

Dave