Thread: Big Thanks to Andy & Paul @ Hard Range

attenuator

Looking good Remy.

Originally Posted by Remy

Paul have you measured those heights for me? Can you PM when you do!

I have not, and I will.

Did I say that my P38 has been living outside? A bit hard to measure heights when it sits on the sloping driveway, while SWMBO's pretty P38 rests on red carpet (yeah, really) in the garage. Hers is going to be out of the garage most of the weekend so I will get some of the mud off mine and put it on the flat surface to measure those heights for you.

Cheers, Paul.

Whats that bullbar originally off?
Is it a good fit?

Originally Posted by Remy

So i have been busy pulling bits of my old (but newer P38 - still for sale on ebay after being stuffed around by two buyers) and refitting them to the 95 model, plus a respray of bonnet side panels, snorkel, bullbar, kaymar rear bar and now trying to fit the snorkel, winch, spotties, rear camera, new stereo combo, haltech and 32 inch tyres and rear locker etc. Also priority 1 was to clean the old one up and get everything working for the new buyer. Remind me not to do this again in a hurry and that if i do i should take a few weeks off work and dedicate it to the car rather than trying to fit life around it!

Also built a little attenuator for the stereo which works great and wired the stereo into the wheel controls and all works (nice!) - now to see if the chinese stereo works longer than a week

I will take a couple of better pics when the job is complete but here are a few as promised.

Paul have you measured those heights for me? Can you PM when you do!

Cheers,
Remy

How do you stay awake for a week?

It is a Disco 2 bar and bracket with the p38 mount trimmed and welded onto the back.

Originally Posted by billy bob

Whats that bullbar originally off?
Is it a good fit?

OK Just about done - warn winch to go once i find a new end cap!
Added my spotties, cb, rear view camera (into Kaymar bar), Bling chrome lettering after paint job, rear DVD headrests for kids, Haltech etc. Photo's as requested.

and more - snorkel (camera next to number plate) - bars and snorkel all colour coded

that looks awesome Remy... makes my weekend's efforts of rewiring/repositioning the air locker and light bar switches pretty ordinary

Here are my lifted heights you wanted, all measured at front right wheel. Allow 10-15mm higher at rear.
Heights are measured from top of the wheel cap to underside of the guard.
Access ----- 410 (820mm to ground)
Low/Hwy --- 480
Normal ----- 515
High ------- 565

Cheers, Paul.