No Heater

Ron, what was the "gunk" in the radiator? What it set like a rock, or spongy? Where do you reckon it might have come from?

Pete

It was relatively hard. I'm not sure from where it originated. I replaced the radiator but also rodded this one out just to see if it was possible. I used a stainless steel backing strip (about 2.5mm x 1mm thick) from a wiper blade.

Quote:

---

Originally Posted by wayneg

Apart from the wiring loom can anyone confirm if all 3 blend motors are the same and can fit any position or are they specific to a position on the car.

---

All the same. There position is identified by the colour of the piece of tubing over two of the cables.