Bull Bar! In melb finally!!

**DANMAL** · 13th February 2013, 05:16 PM

Finally installed ADR approved bull bar in melb on the Rangie.. It's off disco 2 they didn't have to muck around with the mounts therefore cans are untouched.. And he certifies it 😁ImageUploadedByTapatalk1360739742.436775.jpg ImageUploadedByTapatalk1360739777.051049.jpg

**Keithy P38** · 13th February 2013, 05:52 PM

Congrats! So what your saying is that it went straight on?

**DANMAL** · 13th February 2013, 06:21 PM

Originally Posted by Keithy P38

Congrats! So what your saying is that it went straight on?

Well I had a look underneath, they drilled an extra hole in each bracket no cutting though.. All the spacing is the same as disco, they just had prob with height but I didn't see what they did there..
So now he's making them for p38's

**Rabzy** · 13th February 2013, 07:02 PM

How much? And where do I go? Lol Iv been dreaming about a winch bar on the rangie!!!

**DANMAL** · 13th February 2013, 07:51 PM

Originally Posted by Rabzy

How much? And where do I go? Lol Iv been dreaming about a winch bar on the rangie!!!

$1300 fitted! In ballarat

**mtb_gary** · 14th February 2013, 09:29 AM

That's a ice looking bar! Now if only we could get them in Perth

Gary

**redandy3575** · 14th February 2013, 10:56 AM

Originally Posted by DANMAL

$1300 fitted! In ballarat

That's with the bull bar itself included? If so, I might have to give this guy a visit.

Tombie · 14th February 2013, 11:16 AM

Originally Posted by mtb_gary

That's a ice looking bar! Now if only we could get them in Perth

Gary

Its only a freight company away

**fraser130** · 14th February 2013, 01:52 PM

So....S1's, SII's SIIa's SIII's County's, Defenders, D1's, D2's, D3's, D4's, Early RR's, RRC's, P38's, BUT NO L322's!!!!!!

Bugger!

Frustrated Fraser!

**Keithy P38** · 14th February 2013, 02:38 PM

You'd think a D4 bar would fit a 322?

Thread: Bull Bar! In melb finally!!

Thread Tools