Thread: XROX winch/bull bar

Originally Posted by intheozone

Yes, the factory and offices are in Perth, although they sell Australia wide through Opposite Lock and other outlets.

If you want to contact them directly contact details are on their facebook page

Hi intheozone.

Well I'm close to ordering my bar but just thought I'd ask of your thoughts before ordering.

Are you happy with how the tubes goes over and round the guards? Some ways I like the idea as it'll help the front quarter a little with protection but just not sure how far they actually stick out.

Do you have any side on pics of the whole car and bar?

Any insider info on the rock sliders or rear bar?

Have you fitted a winch to yours? If so what did you fit? I'm looking at the Runva 12,000LB, or the Runva 11XP or the Tigerz11 Grande all with rope... Just not sure how well the Runva 12,000LB will fit as its got a fairly large body on it.

Thanks, Peter.

The runva will fit as will the tigerz but the runvas a better unit (my thoughts).

Originally Posted by clubagreenie

The runva will fit as will the tigerz but the runvas a better unit (my thoughts).

Good to hear. Is that the 12,000LB one, the 9500LB one, the 11XP or all of them? I have no idea what the bar looks like in the area that the winch gets attached too.

There's enough width in the cradle section of the bar for just about anything, even the 17500. The EWX 12000 is a good unit, was my only other consideration apart from the modified Goodwinch from the UK.

Got some pics here.
http://www.aulro.com/afvb/1975276-post92.html

Originally Posted by clubagreenie

There's enough width in the cradle section of the bar for just about anything, even the 17500. The EWX 12000 is a good unit, was my only other consideration apart from the modified Goodwinch from the UK.

Got some pics here.
http://www.aulro.com/afvb/1975276-post92.html

Any idea what the access holes in the bar are like for the clutch leaver on the Runva EWX12000 or similar?

There's a cutout for a handle but just rotate the gearbox to suitable point. It's an easy process and would need to be done on any winch more than likely.

What vehicle is it on BTW?

Originally Posted by clubagreenie

There's a cutout for a handle but just rotate the gearbox to suitable point. It's an easy process and would need to be done on any winch more than likely.

What vehicle is it on BTW?

Ah good. Was hoping it was good access. My mates ironman winch with ironman bar wasn't a great fit nor did it bolt up with the bar so well even though they were the same brand.

P38 2000 povo pack

Xrox bar bought. Guy at Opposite Lock said one he just ordered for the P38 was made in 10 days so here's hoping I have it by 2 weekends time.

I ordered from Penrith (further from me but I had my reasons) and he said there is another one on its way to his store for a P38. And when I went into Narellan on the weekend that guy said he had 2 other enquiries. So it looks like there's some interest in this bar. Guess it's because there is only this an one other that has the ADR approved/airbag compliant sticker on it.