When I test drove my P38 all was well as there were no leaks and no book symbol on the A/C. Obviously a couple of test drives don't really mean much as you can't possibly do enough real world testing. Anyway the day after I got it I changed some A/C settings and the dreaded book symbol appeared. It would appear a few minutes into driving on certain settings.
Then whenever I drove I'd lose a bit of coolant (up to 300mL at a time) and if I drove for over 30 minutes then I'd lose a whole lot more especially going uphill. Then it would start overheating and I read all the scary threads about head gaskets and new engines, etc.
Took it back to the roadworthy mechanic who fixed a couple of coolant leaks by replacing the radiator cap and heater hose.. Problem still happened after long drives and I couldn't tell there was less coolant until the next day. I kept topping it up and driving it short distances.
One day my wife finally took it for a drive and changed the A/C settings. Since she did that the evil book symbol hasn't appeared, and the coolant has not leaked one drop! No more overheating! Now.. I'm scared to change the A/C settings because I don't want it to leak again, and I don't want to jinx this good run haha.
Old settings: I would usually turn A/C off but seemed to happen with it on too, have the dash and feet blowers, and whatever temperature set.
New settings: A/C on, only the feet blowers, and I've tried a few different temperature settings with various outside temps (hotter than outside, colder than outside).
So what could the problem be? Is there a link between the A/C faulty book symbol and coolant leaking? Not sure if the colder Melbourne weather has helped but I've driven on slightly warmer days with no problems.
x2 as above ..plus
FWIW: The plenum chamber in the heating system has flap which moves in accord with temp settings. The (plastic) chamber "box" can get slightly out of shape over the years due to heat. This can cause the blend flap to bind, causing the blend motor to stall and resulting in a book symbol. For example, I get no book symbols during winter when the ambient air temp is less than 17 degC... yet, as the day warms up, the book symbol appearsbecause the flap gets jammed and won't cycle through its full arc... not saying this is what your issue is, but it's one of several which can cause problems.
coolant flows through the heating system all the time; it's the blend flap which determines the temperature... what colour coolant are you using in your engine?
EDIT: have a careful look at the front of the engine to see if you have any leaks around the water pump. Check for evidence of coolant leaks with an inspection mirror if necessary, around the rear of the heads and also around the head bolts for #1 cylinder (front LHS -passenger side)
MY99 RR P38 HSE 4.6 (Thor) gone (to Tasmania)
2020 Subaru Impreza S ('SWMBO's Express' )
2023 Ineos Grenadier Trialmaster (diesel)
Hi
Also don't forget to check and replace RL7 in the fusebox if you have or have had the book symbol.
This should extend the life of your fusebox
Steve
Mine used to do that but book symbol hasn't shown for weeks no matter the outside temp and it has reached 20 and also in traffic where other exhaust heat tends to bump up the temp.
Mine has red coolant. Not sure of the ratio to water and how sensitive a Rangie is to that.
1. Yep I realised that and realise I'd probably have to replace the radiator. Been looking at the eBay ones. They any good?
Thing is I don't want to spend money on replacing that before spending money on fixing the leak in case it's something a lot worse.
2. Is that by doing the rolled up newspaper test? I did that and it's all good. I haven't checked to see if it turns on at the right times.
I prefer copper core radiators ... however tho, anything will be heaps better than what you have.
Unfortunately ... You cannot identify "something a lot worse" until you eliminate the radiator .... If you don't, then it is guaranteed that you will overheat the motor and then your up for 4 to 6k for a reco motor.
All sorts of tests available .... Another way is to compare the resistance of your viscous to a new 1 ...
Cheers
Mike
Hi Lapowww,
The two P38's I've had have both had green coolant in them.
HI
You can always go this route
http://www.aulro.com/afvb/p38a-range...m-upgrade.html
Steve
HI
I believe the Bosch models had red coolant, but if you do get a copper core radiator you MUST use green coolant
Steve
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks