Thread: Gen II Calibration

I thought the same many years ago but after spending heaps of money with so called specialists I read forums (rangeroversnet specifically ) many times....over the last 2 years I have rebuilt the EAS ie: valve block,compressor,airbags,dryer etc. Actually it's quite straight forward and once you've driven and towed with it nothing comperes IMHO .

Yeah it sounds complex mate, but it's really quite simple (once you've had an inside look at how it works via Faultmate/nanocom/storey wilson, etc).

So what is LR charging for a calibration these days?

Has anyone enquired lately?

Maybe we could organise a group buy? 😇

Originally Posted by DT-P38

So what is LR charging for a calibration these days?

Has anyone enquired lately?

Maybe we could organise a group buy? 😇

Pay for them with Bit coins?

I originally calibrated it using the heights of the wheel arches and I can confirm that it was never right.

Recently I recalibrated it by removing the bump-stops and just putting several offcuts of 1.5cm thick decking wood on the bump-stop perches at the heights I wanted (same number for each corner) and read out and saved the height sensor values.

Now it works flawlessly. That was the final key needed. Now for some air bag spacers so I can mess it up again...

Let me know what you think of the Gen II's ride quality on & off road, I've been reading mixed reviews...

Well I made a set of Std height blocks and some mayhem ensued !

When it was resting on the blocks I got a "bad height sensor data" error, so I suspect the standard position has wear on the height sensors.

Tomorrow I will swap right with left and see what happens

Steve

If that's for your 1999 then I don't believe swapping from side to side will help you as LR started fitting handed sensors in 1997 unfortunately.

Maybe I'm wrong? Although I double-checked on RAVE and it definitely shows a change to the "newer" sensor in 1997.

Originally Posted by Rage Over

If that's for your 1999 then I don't believe swapping from side to side will help you as LR started fitting handed sensors in 1997 unfortunately.

Maybe I'm wrong? Although I double-checked on RAVE and it definitely shows a change to the "newer" sensor in 1997.

I think you may have it backwards.

If you look here you will see it's the earlier sensors which are "handed" they have part numbers whereas the later ones only have one number with no L or R specified

Allbrit.de - Ersatzteile für LAND ROVER & MG ROVER

ANR2494 and ANR2495 for earlier front ANR4686 for the later ones

Steve