Thread: HCPU tub trailer

Originally Posted by rainman

Where did you get your latches and hinges from Weeds? I just put a similar latch from UES on my tailgate. It wasn't cheap, but quality .

Could ring the guy that built it, he did tell me where he gets his gear from just cannot remember.

Originally Posted by discowhite

Kelvin,
did you take the tent apart to have the awning stitched on or did it
get done insitu?

cheers phil

Yep had to pull it apart well worth the effort, stacks of room now and finishes the trailer off. All I have to do now is switch the cover around, dunno why I didn't do it when I had it apart. Oh and need to buy a 3m tent pole.

Originally Posted by weeds

Could ring the guy that built it, he did tell me where he gets his gear from just cannot remember.

I assumed you built it yourself!

Originally Posted by rainman

I assumed you built it yourself!

you assumed wrong.......i was running out of time getting it ready for our trip north, i ordered it one day and probably cancelled the trip a day or to later

time for an update

i have new motivation to finish the trailer, Wendy is on the road to recovery after i broke her foot so we have two camping with MTB's trips planned

picked up the checker plate for the front section today and have nearly finished riveting it down

i have made the rack for five MTB's, this rack also separates the two spares from the bikes

i have now found the best place for the AUX batteries

fitted rails for the kitchen and storage box to slide between

sorted the wiring

now working on ways to stop the kitchen from bouncing over the rails

might post some pics tomorrow

We eagerly await the pictures. You know we're all keen to check out your rack .

A couple of pics of my rack.........too shy to venture outside so garage shots will have to do

Now will I show off my rack on Sunday??

Oops cannot load pics from iPhone, must work out how to reduce the size of the pics