Thread: Three groove pulley

Good Evening,

I'm looking for a three groove pulley like the one in the drawing below.

The standard one has a flat on the end which is bolted to the centre PTO, the one shown has a mounting face which is recessed

Is there anybody out there who has such a thing and is willing to both sell it and post it to the UK?

Regards

Richard

Shouldn't be too hard to re-manufacture but you need access to a good mate who can use a lathe. It would also be easier to start off with a casting rather than machining from solid.

I have a 'home made' welder but it uses the two belt pulley. The generator pulley has an extra groove for a belt to run a blower which forces air into the commutator area to cool the motor.





Colin