Thread: Getting a chassis galvanised in Brisbane

The size will restrict options. Industrial Galvanizing at Carole Park are the best in town for large pieces.
Avoid the mob at Richlands.

Originally Posted by V8Ian

The size will restrict options. Industrial Galvanizing at Carole Park are the best in town for large pieces.

They've got a place at Pinkemba or somewhere as well, don't they? Seem to remember seeing one.

Originally Posted by Tins

They've got a place at Pinkemba or somewhere as well, don't they? Seem to remember seeing one.

Yes.

When I went to Pinkenba to get a quote on getting all the galvanized bits replated on my 88" they redirected me to their Carole Park operation. Apparently they were better at handling smaller parts which won't apply for a chassis alone.

They did an OK job and I only had the one small part (tailgate pigtail) go missing which was pretty good all considered. There is a minimum charge and weight and as it happened I could have done a second truck as part of it - cost about $400 from memory.

Cheers,

Neil

Originally Posted by S3ute

Yes.

When I went to Pinkenba to get a quote on getting all the galvanized bits replated on my 88" they redirected me to their Carole Park operation. Apparently they were better at handling smaller parts which won't apply for a chassis alone.

They did an OK job and I only had the one small part (tailgate pigtail) go missing which was pretty good all considered. There is a minimum charge and weight and as it happened I could have done a second truck as part of it - cost about $400 from memory.

Cheers,

Neil

Did the chassis get distorted at all, or do only firewalls get distorted ?
Note: Parroting, not speaking from personal experience.
.W.

I chatted to a guy last year.
He worked in the Military and told me the Pile of Galvanized good Perentie Chassis's was the same size as the bent non usable ones.
If the company doing it heats the chassis before dipping, less distortion will occur.
I toyed with the idea of getting my S3 SWB done. Decided against it after I had my 5 rims done but I should have checked them for roundness before sending them off.,
I think the Brisbane factory they went to has closed down.
Rims were $12 each, chassis being around $220.

whitehillbilly

Hi everyone

Thanks for the advice - I reached out to the suggested companies and got pricing back from one of them: $3.86/kg + GST for Hollow Structural Steel 3D fabs charged on the total weight post galvanising. They suggested adding 7-10% to the pre-galvanising weight.

So next question is, how much does a 1958 109 chassis weigh? Does anyone have this information?

Thanks
Wayne

I had a heap of new large steel frames galvanised at the Carole Park operation,recently,by a contractor that also made the frames,and it was not the best quality.
But maybe that is the way it is these days.Around some of the welds the gal did not seem to be 100%,and thin along some of the edges.
Most of the steel was 125PFC girders.

Originally Posted by whitehillbilly64

He worked in the Military and told me the Pile of Galvanized good Perentie Chassis's was the same size as the bent non usable ones.

That's a really bad strike rate. Sounds like galvanising the chassis is very high risk.