ok i will do that next time
Printable View
ok i will do that next time
well have not done much for a while been busy busy busy and going to be busy for the rest of the month but here is what i did today after my 13 hour sleep:angel::eek: i took the sump off the engine and finished the gearbox crossmember off except for holes and actually welding it on
https://www.aulro.com/afvb/images/im...10/05/1200.jpg
https://www.aulro.com/afvb/images/im...10/05/1201.jpg
https://www.aulro.com/afvb/images/im...10/05/1202.jpg
https://www.aulro.com/afvb/images/im...10/05/1203.jpg
https://www.aulro.com/afvb/images/im...10/05/1204.jpg
https://www.aulro.com/afvb/images/im...10/05/1205.jpg
https://www.aulro.com/afvb/images/im...10/05/1206.jpg
https://www.aulro.com/afvb/images/im...10/05/1207.jpg
https://www.aulro.com/afvb/images/im...10/05/1208.jpg
hi Tony
that sump pic brings back memories, the cross member looks very professional and will be stronger than the original.
I know that growing boys need lots of sleep, but 13 hrs must be a record?
Remember, dont neglect your HSC studies for the land rover twins. Priorities are important, and learning is number one :)
Keep up the good work, and less ZZzzzzzzz.......:zzz:
made the gun racks yet for the landie
Peter
lol i was up for about 37 hours.no gun racks yet
Why up 4 so long? you dont have to watch the paint drying you know? :pQuote:
Originally Posted by schmierer LR at singleton
lol umm well i had a guest over
It is comming along quite nicely Tony...keep up the good work;):D
Mrs hh:angel:
Tony,Quote:
Originally Posted by schmierer LR at singleton
I notice that you have the chassis up side down for welding.
Remember to make the chassis completely level, (out of winding) before welding in the new (magnificent) angled cross member. I'm sure that you have remembered that anyway, but just in case, I type it in for posterity :angel:
yeah i know but thanks anyway
well the engine is apart dad did it while i was at an 18th but unfortunately dad doesnt get the concept of a camera,so no photos.took the block pistons crank shaft and head into an engine place today,so i will have some good news soon...hopefully.