Results 1 to 5 of 5

Thread: clutch cover plates

  1. 30th August 2010, 11:21 AM #1
    sykes1
    sykes1 is offline Fossicker
    Join Date
    Mar 2008
    Location
    adelaide sa
    Posts
    49
    Total Downloaded
    0

    clutch cover plates

    Hi all. can any body supply photo's of the,front of the bulkhead, just below the rubber bung,as i have plenty of spare holes to fill in, it is a 2a lwb maybe 67 and its a 6 cylinder bulk head too, any photos would be great, i think the aluminuim plates are missing from there, not sure what they should be

    thanks Andrew
    Last edited by sykes1; 30th August 2010 at 03:29 PM. Reason: wrong part discription
    Reply With Quote Reply With Quote
  2. 30th August 2010, 01:43 PM #2
    JDNSW's Avatar
    JDNSW
    JDNSW is offline RoverLord Silver Subscriber
    Join Date
    Jan 1970
    Location
    Central West NSW
    Posts
    29,511
    Total Downloaded
    0
    Not sure what you are referring to. In the Landrover 2a workshop manual, the clutch cover is what I would refer to as the pressure plate, but I don't think this is what you are after.

    If you mean what blocks the holes in the bell housing - the one on top is blocked by the mounting bracket for the gear lever, the one on the left has a rubber grommet, and the one on the right has a rubber grommet that the clutch shaft goes through.

    Or do you mean the floor panels?

    John
    John

    JDNSW
    1986 110 County 3.9 diesel
    1970 2a 109 2.25 petrol
    Reply With Quote Reply With Quote
  3. 30th August 2010, 03:26 PM #3
    sykes1
    sykes1 is offline Fossicker
    Join Date
    Mar 2008
    Location
    adelaide sa
    Posts
    49
    Total Downloaded
    0
    the panel on the bulk head, my memory is going ha ha, below the rubber bung
    Reply With Quote Reply With Quote
  4. 1st September 2010, 01:54 PM #4
    UncleHo's Avatar
    UncleHo
    UncleHo is offline AT REST
    Join Date
    Oct 2003
    Location
    Godwin Beach Qld
    Posts
    8,688
    Total Downloaded
    0
    G'day Sykes1


    The panel you are refering to is the clutch housing cover panel or the rear engine cover housing, also known as the gearbox front cover housing



    cheers
    Reply With Quote Reply With Quote
  5. 1st September 2010, 07:18 PM #5
    peterg1001
    peterg1001 is offline Master
    Join Date
    Feb 2009
    Location
    Warrimoo, Blue Mountains, NSW
    Posts
    312
    Total Downloaded
    0
    I think Andrew might be referring to the holes in the bulkhead where the hand throttle pokes through. If the hand throttle mounting plate is missing, there's a rectangular hole left over.

    I've attached a photo, where the hand throttle hole has a cover plate over it. And is the rubber bung you're referring to the grommet for the speedo cable?

    Peter
    Attached Images Attached Images
    Reply With Quote Reply With Quote
« Re-wiring 2a issues | Our weekend out »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!