Thread: 1st Time on the Road! GB noises??

OK the chirping noise MAY to be squeaking from the GB cover plates. It's not there cold, only after it warms up. I will go around tightening stuff & spraying silcone lubricantn along the joins. Only in top gear tho. The "direct drive" throws up a different vibration cf the indirect gears???

The clanking? I CAN"T be the uni's as I get about 3 "clanks" per wheel revoultion instead of one. I will jack her up, select low ratio & just let it idle in gear and listen.

Originally Posted by geodon

I also get a "clank-clank-clank" as I cruise to a halt clutch in. This sounds like a uni inside the front diff but I did check each one carefully?

I know nothing of the Series LRs but if it was a later car, my money would be on a sticking/tight handbrake.

what about prop shaft uni joints,
yes straight cut 1st and reverse from memory.

Originally Posted by geodon

........

1st impression: were ear muffs an optional extra?

No, but it might have been an idea - however, I noted how quiet mine was after a partial strip to paint and reassemble with all body panels tight and all new rubber plugs etc.

There's a high frequency cricket chirping noise in top gear hi-ratio. Familiar to anyone?

No

I also get a "clank-clank-clank" as I cruise to a halt clutch in. This sounds like a uni inside the front diff but I did check each one carefully?

This suggests either it is stuck in four wheel drive, the handbrake is dragging, or both. May also indicate that some of the U-joints or splines are a bit worn. Also check that the U-joint flange bolts are not loose, both front and rear shafts.

MAN! Is 1st gear straight cut??

yes. so is reverse. Excessive noise may suggest worn components, but if you are not used to straight cut gears, it may not have anything wrong. As long as ithe noise is uniform, don't worry.

Apart from these, it drove & stopped well (good ole VH44!) but it sure made my split screen Kombis seem like winged gazelles!

Performance should be comparable to the kombis, may improve with the handbrake not dragging.

John

Clanking noise gone. I thought the handbrake was quite free but I gave it a few more clicks away & that did it. Thnx to all. It would have been the last place I looked.

Chirping still there but it sure sounds like a body or mount squeak. I will try to duplicate it on stands.