Thread: Series II starter issues

Check your cables from the battery to the starter switch and then to the starter. Also check your resistance from the engine to the chassis and battery earth. Where are you measuring full volts? On the battery or at the starter? Could just be high resistance there. Check the voltage at the battery when cranking, then take the same reading at the starter motor - they should be quite close. If not, whip it put and crack it open - it may only need new brushes or a good clean of the commutator.

There are low voltage, high torque starters available for MGs now that are half the size and spin the thing like a power drill with minimal battery drain (or so they claim). Are such beasties available for Landy's and if you live in a difficult area (snow all over your Landy sounds 'difficult' to me), is it worth upgrading?

Originally Posted by crackers

There are low voltage, high torque starters available for MGs now that are half the size and spin the thing like a power drill with minimal battery drain (or so they claim). Are such beasties available for Landy's and if you live in a difficult area (snow all over your Landy sounds 'difficult' to me), is it worth upgrading?

They are certainly available for later Landies - I put one on my 86 RRC and it nearly jumps out of its skin when I hit the starter!

If these are available for early LR's I'd highly recommend one.

Originally Posted by bacicat

They are certainly available for later Landies - I put one on my 86 RRC and it nearly jumps out of its skin when I hit the starter!

If these are available for early LR's I'd highly recommend one.

Available for MGBs (1961 onwards) so things look good

Try using a jumper lead direct from battery earth to one of the securing bolts of the starter & see if that helps with the cranking , that will climate all the earth connections. It has been our experience with the high torque starters the contacts in the solenoid give trouble . We only get about 3years use with the one on the Jag we race , &you need to make sure your battery always has folk voltage . We have never been Abel to get any body to repair them & have had to buy a new starter when the solenoid stops working.

Summitt


I had exactly the same issues despite a new starter motor. I found that the nut and bolt holding the cable from the positive battery terminal to one of the legs of the battery tray was only finger tight. Access is very tight so I had to remove the battery to find the issue. But once I removed that cable and cleaned up all the contacts and re-bolted it nice and tight I have a healthy starter motor.


I hope this helps.


Nic