Results 1 to 5 of 5

Thread: Series IIA Carby Kit.

  1. 20th July 2006, 03:52 PM #1
    RobHay's Avatar
    RobHay
    RobHay is offline ChatterBox
    Join Date
    Jan 1970
    Location
    Caboolture.Qld
    Posts
    2,382
    Total Downloaded
    0

    Series IIA Carby Kit.

    Does anyone know where I can get my hands on a carby kit for a zenith carby.
    Mine thinks it is a air compressor and is sucking air gloriously, naturally the engine starts, runs extremely well for 16.75 seconds and then dies never to start again until it is given another dose of highly expensive fluid down its throat.

    Bloke at Repco asked "You sure you got the name right"
    Reply With Quote Reply With Quote
  2. 20th July 2006, 03:57 PM #2
    RobHay's Avatar
    RobHay
    RobHay is offline ChatterBox
    Join Date
    Jan 1970
    Location
    Caboolture.Qld
    Posts
    2,382
    Total Downloaded
    0
    Followed up Repco, different person, must have been older knew what I was talking about.
    Turns out they do have them for.......... WAIT FOR IT!
    $63.99 ( ouch, ouch, ouch)

    any cheaper price out there.

    Wasn't someone selling a solex carby for about $100.00
    Reply With Quote Reply With Quote
  3. 20th July 2006, 04:20 PM #3
    Phoenix's Avatar
    Phoenix
    Phoenix is offline Swaggie
    Join Date
    Jun 2003
    Location
    Launceston, Tasmania
    Posts
    12,347
    Total Downloaded
    0
    $44 from four wheel drives in melb for an overhaul kit.
    1994 Discovery TDi
    2004 Discovery 2 TD5
    2010 Discovery 4 TDV6
    1961, Series 2 Ambulance. 108-098 - Eden

    Registry of Ex Military Land Rovers Mem. 129
    Defence Transport Heritage Tasmania Member
    Reply With Quote Reply With Quote
  4. 20th July 2006, 08:52 PM #4
    JDNSW's Avatar
    JDNSW
    JDNSW is offline RoverLord Silver Subscriber
    Join Date
    Jan 1970
    Location
    Central West NSW
    Posts
    29,511
    Total Downloaded
    0
    Last Zenith kit I got from them had an off centre needle valve seat that would not screw in - but they replaced it without question. Even offered to rebuild the carby if I brought it in, which was hardly practical as it was 1000km away.
    John
    John

    JDNSW
    1986 110 County 3.9 diesel
    1970 2a 109 2.25 petrol
    Reply With Quote Reply With Quote
  5. 21st July 2006, 06:20 AM #5
    Michael2's Avatar
    Michael2
    Michael2 is offline ChatterBox Supporter
    Join Date
    Jan 1970
    Location
    Melbourne
    Posts
    2,972
    Total Downloaded
    0
    I think I've got a couple of good Zenth 36IV (SIII) carbys in the shed. Both recently reco'd. I put a dble barrel weber on my 2.25.

    PM me if you'd like to buy a carby.
    Reply With Quote Reply With Quote
« Series IIA Crash Box | Series II (original) gearbox noise »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!