Thread: Seat frames and rails

Seats remained the same for series 2/2a/3 long and short, except:-

Adjustable driver seats became optional somewhere about 1965, were standard (I think) on station wagons from the start. Became standard on at least Australian built late Series 3 lwb. The driver's cushion on these is slightly smaller, but the standard cushion can be made to fit by putting wooden chocks on it. They were never factory fitted except to the driver's seat. Other seat positions have a simple top hat rail with the bracket for the back welded to it, and bolted to the seat box.

High back seats became optional on later Series 3, and again,became standard on very late Australian built lwb Series 3.

Note that the middle cushion and back are narrower than the left and right.

Best bet for the seat fittings is probably second hand - there must be hundreds of them lying round. Cushions and backs can be bought new.

Originally Posted by JDNSW

Seats remained the same for series 2/2a/3 long and short, except:-

Adjustable driver seats became optional somewhere about 1965, were standard (I think) on station wagons from the start. Became standard on at least Australian built late Series 3 lwb. The driver's cushion on these is slightly smaller, but the standard cushion can be made to fit by putting wooden chocks on it. They were never factory fitted except to the driver's seat. Other seat positions have a simple top hat rail with the bracket for the back welded to it, and bolted to the seat box.

High back seats became optional on later Series 3, and again,became standard on very late Australian built lwb Series 3.

Note that the middle cushion and back are narrower than the left and right.

Best bet for the seat fittings is probably second hand - there must be hundreds of them lying round. Cushions and backs can be bought new.

This is great info, thank you!

4WD Industries and a few other places seem to have the same two types of bases/backs available as a set, listed as standard and deluxe. Are either of these considered high back? It's not something I'd considered. Mine currently doesn't have a middle seat either, so I'd need a frame for that too.

Any suggestions on where to find used frames?

Whereabouts are you? I probably have most of the parts you need, but I am about to leave for Cooma and cannot look. And they will be attached to other bits, and I doubt I am up to pulling them apart.

Send me a PM after Easter. There may be others closer to you.

Originally Posted by JDNSW

Whereabouts are you? I probably have most of the parts you need, but I am about to leave for Cooma and cannot look. And they will be attached to other bits, and I doubt I am up to pulling them apart.

Send me a PM after Easter. There may be others closer to you.

Thanks! I'm in the Lithgow/Bathurst area. Enjoy the event, I wish I could've made it.

How about dropping over some time after Easter and see what I can find. also show you how it goes. I am less than three hours from Bathurst.

New ones being made here. Scroll Down.
Mic Heinrich | Facebook

whitehillbilly