Thread: Series 3 Starter Motor ??

Thanks folks for the suggestions. I have contacted rovers parts near ballarat and have ordered a new spring plus some new hoses I needed. Will see if that does the trick.

Really appreciate the help - very new to the 'fixing' up bit with an old landrover and as a mechanic I would make a good gardner, so advice like this is gold

Cheers, Jonathan

Originally Posted by gromit

Some auto electricians could still have Lucas parts and may be able to help. Mind you, I've tried a few in the Eastern suburbs of Melbourne and they have thrown all the Lucas stuff away (one sold everything via Ebay, most went to the US).

Is the retaining cap at the end held in place with a circlip (some are bolted)? If so you need to compress the new spring to install the clip.
I have a compressor somewhere I can take a photo of if you need details.

Freight of a starter motor from the UK would add quite a bit to the cost.


Colin

A photo of the compressor would be good - it is a circlip rather than a bolt.

I've had this a few years but it was a commercially available compressor back in the UK.



There's a recess on the inside of each plate that fits snugly over the washer/spring so that it can't slip off.

Hope this helps.


Colin

I can supply second hand one if you are still looking