Results 1 to 6 of 6

Thread: Baby seat in a series 3

  1. #1
    Join Date
    Jul 2007
    Location
    Western Australia
    Posts
    52
    Total Downloaded
    0

    Baby seat in a series 3

    I was just reading the Defender thread on baby seats and wondered who has put baby seats in the front of series vehicles.

    I have a series 3 109 stripped ready for rebuild that down the track would like to take my daughter out for the occasional cruise.

    As a kid ( in the 70s ), I stood on the front seats of a series 2 Landy and our family drove all over the place.

    Would love to hear stories, present and from the past.

    Cheers

    John

  2. #2
    Join Date
    Dec 2006
    Location
    Narrogin WA
    Posts
    3,092
    Total Downloaded
    0
    My kids are adults now, so I am out of touch with the rules, but I think I read recently on AULRO, that infants and kiddies up to about 7 are not allowed in a front seat at all!

    Have a search on your State Transport website,

    Cheers Charlie

  3. #3
    Join Date
    Jan 1970
    Location
    Invermay Tasmania
    Posts
    1,732
    Total Downloaded
    0
    Depending on which state your in but the rule goes something like this

    NO rear facing seats at all

    From 6 months (not 100% sure on this age) to 4 years front face seat which must be secured via anchor point and harness

    From 4yrs-7yrs booster seat required (only if child is large enough) well thats what my son is in now (5) and all is correct here in TAS

    The rules say that if there is only 1 set of seats then the child is allowed in the front unless there in a rear facing seat eg ute etc etc

    There are some othere points to consider but check with your state department

    Adam

  4. #4
    Join Date
    Dec 2006
    Location
    Narrogin WA
    Posts
    3,092
    Total Downloaded
    0
    Here are the rules in WA - looks as if kiddies can ride in the front.

    "Children's seat belts and child restraints
    Drivers are legally responsible for ensuring that children are suitably restrained in a vehicle in accordance with ‘Seatbelt rules – Law effective 1 October 2010’ shown below:
    From birth up to the age of six months to be restrained in a rearward facing child restraint(e.g. infant capsule);
    From six months up to the age of four years to be restrained in either a rearward or forward facing child restraint with in-built harness; and
    From four years up to the age of seven years to be restrained in either a forward facing child restraint or booster seat restrained by a correctly adjusted and fastened seat belt or child safety harness;
    Children seven years and over can be restrained in an adult seat belt or booster seats.
    If a child is not wearing a seat belt or a suitable child restraint as required by the law, then the driver risks being fined and incurring demerit points. You must not drive your vehicle with unrestrained children in it if there are positions with seat belts available.
    Before you purchase or install a child restraint, make sure it complies with Australian Standards. For more information about fitting child restraints and the Road Safety Council’s network of Child Car Restraint Fitters in Western Australia, read our Child Restraint information bulletin." Dept of Transport, WA.

  5. #5
    Join Date
    Jan 1970
    Location
    Narre Warren South
    Posts
    6,801
    Total Downloaded
    0
    I have a small lump on my nose from hitting the windscreen of my Dad's Ford Prefect when he stopped suddenly (I was a young fella so it was a long time ago).
    In the UK I drove an Austin Somerset with no seatbelts and carried my nephews in it (much to my sister's disgust)
    I now drive a Series I with no seatbelts but I cannot take my kids in it until they are 7 years old and over a certain weight (my wife worries whenever I take the kids out in it). The new child restraint laws are fully retrospective.

    With a legal/proper child seat or harness, depending on their age, you could carry them in the front if it's a ute (is your 109" a 3 seater ?). The question is whether you can legally just fit a bolt yourself into the bulkhead or whether it has to be done by an 'authorised person' ?
    I had the rear bar fitted to my Defender when I got it years ago and that allows 3 child restraints to be used in the second row.

    Just a thought, with the pace most of us rebuild Land Rovers at, will your daughter still be living at home when it's finished ?

    As already mentioned, check with your State Department for the finer details.



    Colin
    '56 Series 1 with homemade welder
    '65 Series IIa Dormobile
    '70 SIIa GS
    '76 SIII 88" (Isuzu C240)
    '81 SIII FFR
    '95 Defender Tanami
    Motorcycles :-
    Vincent Rapide, Panther M100, Norton BIG4, Electra & Navigator, Matchless G80C, Suzuki SV650

  6. #6
    Join Date
    Apr 2008
    Location
    Gold Coast, Qld.
    Posts
    145
    Total Downloaded
    0
    Hi John,

    I've got a shorty with a dickie seat in the rear which has been Eng./plated. Now I'm getting a crab bar fitted and Eng/plated to be able to fit a child seat/s in legally. Good thing about the crab bar is it is rated to 900kg - so handy when I have the child seat out as I can use it to tie down gear in the back or undo 2x bolts to remove it if not needed or in the way when not driving with young fella in the back.
    Bullets

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!