Thread: Gearbox overhaul time - suggestions wanted.

I got a 'kit' from the UK some time ago, the bearings were 'no name' but it did come with all the springs, seals & lock washers etc.
From memory the seal between the gearbox & transfer box was originally double lipped but difficult to replace so a single lip seal tends to be supplied.

Some bearings/seals you'll be able to get at a bearing stockist some will be specials, there were a couple of lists of bearings on the forum somewhere.
You might need synchro rings.

Here's the kit I got PSK 1024 REP - Overhaul Kit, Series 3 Gearbox, Replacement specification

When I stripped my box, true to the PO's word, it had been reconditioned so only a couple of springs & one bearing had to be changed, details in my C240 thread.

Some info here http://www.aulro.com/afvb/series-lan...earbox-id.html including a list of 2a gearbox bearing numbers.


Colin

Hello Bacicat,

I found this link a while ago about removing and rebuilding a Series 3 box. I hope it is of some help to you? Series Land Rover Gearbox Rebuild. Plus here are a couple of YouTube clips about the same project [ame]https://www.youtube.com/watch?v=_yzUH1faG5Y[/ame] & Part Two. This does not show the job being finished and I cannot find a concluding Part 3 [ame]https://www.youtube.com/watch?v=mo-IXLSZ5R4[/ame]

Kind Regards
Lionel

Hopefully your synchro hub is OK........ Land Rover Parts - GEARBOX - SERIES 3

Might be worth asking them what brand bearings they supply.


Colin