Thread: Series 111 engine oil cooler?

Originally Posted by Gippslander

During the disassembly of the 2.6 engine i have removed the oil filter and adapter housing to prevent damaging it when i lift the motor out of the chassis. In doing so i also removed the oil cooler and pipes, i will need to replace the existing hose sections of the cooler but am unable to find a part number for these. In fact i cant find an oil cooler listed in the parts manuals, is this an aftermarket adaption or a genuine Land Rover fitment, can someone assist me with this or shall i just take the current hose sections to a hydraulic shop and have them make what i need. I have attached photos of the oil cooler and filter installation.
Gippy

Standard fitment.
I got replacement hoses from a seller in Cooma 2018.
I'd have to try and track down a part number.


Colin

From the Optional Equipment Parts Manual (RTC9842CE) both hoses are the same 592040.

Originally Posted by JDNSW

From the Optional Equipment Parts Manual (RTC9842CE) both hoses are the same 592040.

I did a quick online search and came up with a different part number (537516).

I'll have to see if there are any part numbers on the pipes I purchased. There would have been a lot from the army auctions when the Series III was demobbed.

I did get a hydraulic company to look at the hoses, they could re-use the fittings and it's only a relatively low pressure compared to a hydraulic hose. I think I was being a bit 'anal' at the time and wanted the same spiral wrap to look 'original' so I didn't go ahead. Then I found NOS ones at Cooma.




Colin