Reply With QuoteLooks like a completely standard centre. The type with the flat section on the bottom was used on all coillers and from mid 70's or so on series.
Try some fine sand paper on the seal face. If that doesn't work it will need a speedy sleeve.
Master
SubscriberHi,
Whilst repairing my brakes on my 1978 Series 3 LWB. I have stripped down the swivels and funny enough suddenly the front axle was off too. Leaking pinion seal and shot U/J's either end of the propshaft.
Going to replace bearings etc.
What I need to know is what axle is this.
DSC_0149.jpg - Image - Photobucket - Video and Image Hosting
DSC_0151.jpg - Image - Photobucket - Video and Image Hosting
DSC_0153.jpg - Image - Photobucket - Video and Image Hosting
It is not the one shown in the book that I have. I suspect it is from a later Series 3 or later Land rover.
Advice on type and were to get bearings and seals from.
O and would the flange need replacing or could it be cleaned up?
Cheers Chilly
Swaggie
Looks like a completely standard centre. The type with the flat section on the bottom was used on all coillers and from mid 70's or so on series.
Try some fine sand paper on the seal face. If that doesn't work it will need a speedy sleeve.
RoverLord
Isuzurover is correct.
John
John
JDNSW
1986 110 County 3.9 diesel
1970 2a 109 2.25 petrol
Posting Permissions
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks