Results 1 to 3 of 3

Thread: Stage 1 Heater Hose

  1. 26th March 2009, 09:33 PM #1
    Sam Ball
    Sam Ball is offline Master
    Join Date
    Jul 2006
    Location
    Beaumaris Melbourne
    Posts
    211
    Total Downloaded
    0

    Stage 1 Heater Hose

    Noticed one of the heater hoses had a hole in it, so am currently trying to replace itm but the outlet on the engine is considerably bigger than that on the heater - the hose I bought is the same diameter the whole length and not sure if I can get it on - is there a land rover specific hose I need?
    Reply With Quote Reply With Quote
  2. 28th March 2009, 10:17 AM #2
    Tank's Avatar
    Tank
    Tank is offline AT REST
    Join Date
    Jan 1970
    Location
    Moruya Heads/Sth. Coast, NSW
    Posts
    6,532
    Total Downloaded
    0
    Probably, buy a bit of hose that fits the big end, then buy some copper pipe fittings to match the big end and the small end (a reducer), solder them together and join the 2 different size hoses or go to an exhaust place or plumbers shop and have them make you a reducer out of copper or stainless steel, Regards Frank.
    Reply With Quote Reply With Quote
  3. 30th March 2009, 09:14 PM #3
    Sam Ball
    Sam Ball is offline Master
    Join Date
    Jul 2006
    Location
    Beaumaris Melbourne
    Posts
    211
    Total Downloaded
    0
    Thanks Tank, it seems they don't make these anymore, but a heater hose from a Falcon is very close - a little large, but the clamp seems to hold it on tight enough - at this stage anyway.
    Thanks again, if this gives no joy long term will go for your solution.
    Reply With Quote Reply With Quote
« Newbie buying his 1st Landy...is it a good one?! | Spotted on the road »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!