Thread: Another Series

Well its a series 2 SWB soft top.no canvas.
Rear spring hanger rusty, so can't get a number.
Can't find any other numbers, except a small Leyland square plate near the gear lever plate inside on firewall. Would this plate with 2sets of numbers, shed any light on year.
Parked up paddock basher.looks like some sort of SU carby maybe. No air cleaner.
Looks like some kind of tar, sprayed around the underside bonnet and engine bay.
But do I need another ???? Just have to see how many cartons it cost me.

If it has a Leyland plate it must be later than 1967 when Rover merged with Leyland, probably several years later, as I doubt they got their labelling changed immediately in Australia. (assuming the bit with the label is original to the vehicle!)

And on a 2a the 'gear lever' plate has the chassis number stamped on it near the top.
John

Thanks John,
So dates for S11 are ?
S11A are ?
Start of S111 ?

whitehillbillies

Series 2 - 1958-61

Series 2a - 1961-71

Series 3 - 1971 - 1983 (but production of the 88 continued until the 90 was in production, and a few were produced up to the end of the 90s.

Changeover date in each case was always (I think), the UK summer holidays, but some time later for Australian assembled vehicles, I think in some cases even into the next year. And arrival of the new model at dealers could have been a bit later again.

The only real design change from Series 2 to 2a was the diesel engine increased from 2.0 to 2.25, and there were more obvious changes through the remainder of the 2a production.

Series 2a to 3 showed more obvious changes, particularly the instrument panel moving from the centre to in front of the driver, and a padded dash, but again, there were a lot of changes through the rest of the Series 3 production.

John

Thanks John,
Looked at the Leyland plate in Burt and It has the chassis No, stamped on it.
Waiting for a text about the S11.

whitehillbilly