Series IIA Carby Kit.

[RobHay]

Does anyone know where I can get my hands on a carby kit for a zenith carby.
Mine thinks it is a air compressor and is sucking air gloriously, naturally the engine starts, runs extremely well for 16.75 seconds and then dies never to start again until it is given another dose of highly expensive fluid down its throat.

Bloke at Repco asked "You sure you got the name right"

[RobHay]

Followed up Repco, different person, must have been older knew what I was talking about.
Turns out they do have them for.......... WAIT FOR IT!
$63.99 ( ouch, ouch, ouch)

any cheaper price out there.

Wasn't someone selling a solex carby for about $100.00

[Phoenix]

$44 from four wheel drives in melb for an overhaul kit.

[JDNSW]

Last Zenith kit I got from them had an off centre needle valve seat that would not screw in - but they replaced it without question. Even offered to rebuild the carby if I brought it in, which was hardly practical as it was 1000km away.
John

[Michael2]

I think I've got a couple of good Zenth 36IV (SIII) carbys in the shed. Both recently reco'd. I put a dble barrel weber on my 2.25.

PM me if you'd like to buy a carby.