Results 1 to 5 of 5

Thread: Disco 2 interior lights go off too soon

  1. 8th August 2010, 10:25 AM #1
    Fencepost
    Fencepost is offline Fossicker
    Join Date
    Aug 2010
    Location
    Auckland
    Posts
    28
    Total Downloaded
    0

    Disco 2 interior lights go off too soon

    I have just purchased a disco 2 td5 2003 that has a rather annoying feature that i though was just bad design but reading the manual, may be a fault. If you open any of the doors the interior light comes on as expected but then turn off after about 15 sec while the door is still open. Opening any other door will not bring them on either. You have to shut all doors then open one again and the cycle repeats. With the door open you can trigger the locks open with the button on the key and get another 15 sec. Makes getting the kids in their car seats at night a major pain. I have taken to turning them on manually but then usually forget to turn them off until i am buckled in myself. Any ideas? Looking at the wiring diagram i cannot see what would cause this fault. All the door switches are working or the lights would not turn on at all (or go off). Bad BCU? Everything else works fine.
    Reply With Quote Reply With Quote
  2. 8th August 2010, 10:52 AM #2
    Graeme
    Graeme is online now Swaggie Vendor
    Join Date
    Jan 1970
    Location
    NSW SW Slopes
    Posts
    12,036
    Total Downloaded
    0
    I can't remember the exact timing details, but this sounds like transit mode is set. There is a procedure to get the vehicle out of transit mode but that's something else that I can't exactly recall. Its documented in the LR workshop manual (on RAVE) IIRC.
    MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
    VK2HFG and APRS W1 digi, RTK base station using LoRa
    Reply With Quote Reply With Quote
  3. 8th August 2010, 11:25 AM #3
    dmdigital's Avatar
    dmdigital
    dmdigital is offline OldBushie Vendor

    Gold Subscriber
    Join Date
    Jun 2006
    Location
    Arnhem Land, NT
    Posts
    8,492
    Total Downloaded
    0
    You can get the Disco out of transit mode by simultaneously holding down the rear window demist and the rear fog light switches and turning the ignition switch from position 0 to position III for 2 seconds.
    MY15 Discovery 4 SE SDV6

    Past: 97 D1 Tdi, 03 D2a Td5, 08 Kimberley Kamper, 08 Defender 110 TDCi, 99 Defender 110 300Tdi[/SIZE]
    Reply With Quote Reply With Quote
  4. 8th August 2010, 05:58 PM #4
    Fencepost
    Fencepost is offline Fossicker
    Join Date
    Aug 2010
    Location
    Auckland
    Posts
    28
    Total Downloaded
    0
    shear genius-
    I had the bcu out and the multimeter cranked up. No mention of Transit mode on the haynes manual and i jumped straight into the wiring diagrams on rave rather than reading the manual. Anyway, all fixed.
    Thanks a lot. I wonder if it had been like that from the factory? Unfortunately the previous owner has gone overseas.
    Reply With Quote Reply With Quote
  5. 9th August 2010, 06:21 AM #5
    Graeme
    Graeme is online now Swaggie Vendor
    Join Date
    Jan 1970
    Location
    NSW SW Slopes
    Posts
    12,036
    Total Downloaded
    0
    My 2nd D2 was delivered still in transit mode. It was easily cleared when I woke-up to the fact .
    MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
    VK2HFG and APRS W1 digi, RTK base station using LoRa
    Reply With Quote Reply With Quote
« BOSCH ALTERNATOR TO TDI 300 | Which Bolts to use »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!