torque wrench settings

**DODGE** · 14th September 2010, 09:33 PM

Gday all

Wondering if anyone out there would have the torque settings for the bolts securing the swivel housing to diff housing on the front diff and also the rear stubs to diff housing. vehicle is a 96 defender 110.

Thanks in advance. gary

**TimNZ** · 14th September 2010, 09:39 PM

Swivel housings to axle tube 73 Nm (With loctite 720)
Stub Axle to Rear axle housing 65 Nm (Rover and Sals Diff)

Source: LR Defender workshop manual 1996

Cheers,

**abaddonxi** · 14th September 2010, 09:59 PM

This it?

Fit swivel pin housing

36. Coat swivel bearing housing to axle casing bolts
with Loctite 270 or equivalent.

37. Coat both sides of joint washer with a sealing
compound. Position swivel bearing housing to
axle mating face.

38. Place retaining plate, joint washer and oil seal
over axle flange ready for assembly.

39. Fit swivel bearing housing to axle flange with 7
bolts. Tighten to 73 Nm (54 lbf/ft).

**DODGE** · 15th September 2010, 08:32 AM

Thanks guys, i need to invest in a better manual.

Thread: torque wrench settings

Thread Tools

torque wrench settings

Bookmarks

Bookmarks

Posting Permissions