Reply With QuoteI have repaired a similar thing, hacksaw off the barbed bit from a 6mm air hose fitting, drill out the remaining plastic bit a little to the right id and glue it in.
JC
On these forums people often ask for help on why their crusie control system is not working, usually it's just a split hose or the pedal air switched are not working.
Here's another reason.
I found the air hose to the compressor was loose, it was not connected at the attaching nipple .
The nipple had corroded away. Now I have to find some sort of nipple to attached and glue back there to get it operating. Any one had this problem and was able to repair it?
Swaggie
I have repaired a similar thing, hacksaw off the barbed bit from a 6mm air hose fitting, drill out the remaining plastic bit a little to the right id and glue it in.
JC
I have replaced all the hoses and I am still not getting any joy. I am about to look at the brake switch.
ForumSage
Test the brake switch whilst in place, as per RAVE manual. I'd even suggest slavishly following the Troubleshooting Proceedure. Made life easier when I did...
I did'nt at first... got 'perfect' result with it out... did'nt work when mounted. - Needed only a tenth of a mm differance in movement.... (Classic)
It's a bit of a worry... seeing plastic corroded/eroded away like that. Have you tried re-building it with something like Q-Bond ? - a 'super-glue' with filler powder. I've had success with a variety of plastics, including some that have'nt bonded with other adhesives.
The 'Q-Bond' superglue is a better formulation than most other cheaper S/glues. About $35 when I last bought a kit.
Posting Permissions
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks