Thread: Bell autos boost box installation

Ive got one on my car outside, fitted by Pete. Will check it in the morning and see what pin and wire colour it is.

J

Beauty thanks Jon. It would be good to get it fitted tomorrow. Fitted the boost gauge today so i can see what i am doing to the poor donk.

Cheers Jim

How have you found yours Jon?

Every thing i have read says not to go past 18psi, but mine seems to be there already, with out the box.

What boost do you run?

Ok So maybe a few too many beers. The wire is white with an orange stripe. But still it is meant to have a yellow stripe. Maybe orange is close enough.

Would still like to hear how yours is hooked up Jon.

Cheers Jim

OK, 3 wires. 2 green and one purple.

Purple goes to the earth stub on the bottom of the ecu seat box.

One green wire is connected to the white with yellow stripe (outside of either ecu plugs (cant remember where the white & yellow stripe came from, suspect the red plug).

The other green wire from the box is connected into the plug as show in the photo - its the big fat green wire you need to look for, 6 in from the top right).

Hope that helps.
J

Thank you for the picture John.


Pete


PS email me over a contact phone number ill give you a call, tell me the time difference though or ill call you in the middle of the night by mistake lol