-
13th April 2012, 09:18 AM
#1
Brake Caliper Rebuild
Has anyone replaced the seals and pistons in a defender brake caliper. Looks like a pain to do without separating the caliper. I know Land Rover say don't separate the two halves of the caliper- not sure why. I was going to fit stainless pistons and new seals. The current pistons look a bit corroded. I do a lot of beach driving.
-
13th April 2012, 09:21 AM
#2
No need to seperate the caliper halves, seals are hard to come by anyway. Just use a wooden hammer handle or similar between the two sets of pistons and gently blow them out a little toward each other with compressed air. Seeing that you are replacing the pistons, just grab them with multigrips and wiggle each one out and file them in the appropriate receptacle. (Bin)
JC
-
13th April 2012, 05:47 PM
#3
I just recently did mine(county),I had to seperate the calipers to fit spacers for vented discs that made the job a lot easier,the spacer kit came with new seals
Be careful of cheap piston seal kits,I saw one kit that 2 seals would have been unusable and the quality of the rest was poor.
jim.
The part number for the seals if your seperating the calipers should be 17H8764L
Last edited by yt110; 13th April 2012 at 06:11 PM.
Reason: add P/N
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Search AULRO.com ONLY!
|
Search All the Web!
|
Swaggie
Reply With Quote
Bookmarks