Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: Transfer case, Auto or diff(s) - massive backlash

  1. #11
    350RRC's Avatar
    350RRC is offline ForumSage Silver Subscriber
    Join Date
    Mar 2008
    Location
    Bellarine Peninsula, Brackistan
    Posts
    5,502
    Total Downloaded
    0
    Hi Toppa,

    I think your handbrake may be sticking or be adjusted too tight.

    My POS does something similar when its not off properly. (3 speed auto and LT95 TC......same principle though)

    cheers, DL

  2. #12
    Join Date
    Aug 2010
    Location
    Bermagui
    Posts
    477
    Total Downloaded
    0
    An interesting update.......

    Still havent fitted the ATB but i did clean the MAP sensor which has influences on fueling (and possibly gear changes) and it has made a remarkable difference. I still have backlash, but the gear changes, both up and down, are much much smoother.

    The MAP sensor was absolutely chock a block full of oily gunk!! Cleaned the EGR while I was there. I should get around to removing it one day!

  3. #13
    Join Date
    Feb 2011
    Location
    Brunswick, Victoria
    Posts
    3,778
    Total Downloaded
    0
    If the centre diff is shagged you'll get lots of backlash. I replace the TC in mine about 2 weeks ago, and even with the centre diff locked there you could still turn the output flanges 10-15 degrees in opposite directions, then turn them a little further with an accompanying graunch.

    Having replaced the rear diff and TC with supposedly good used units the backlash is significantly reduced.

    cheers
    Paul

Page 2 of 2 FirstFirst 12

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!