Maxi Drive

If you did it yourself the cost of a CV which varies from about $80 to about $150 or so on Ebay plus new seals if you are wise.
IMHO it would be about 2 hours to 4 hours labour at whatever you pay,say at $100 per hour $200 to $400.
It could be an axle of course which would cost about the same.
You can only find out more accurately by asking a specialist near you.
Regards Philip A

Thanks Phillip

You need to open it up and see what is damaged. Plan to replace the hub and swivel seals as a minimum. Download a genuine workshop manual and dig into it. It is a good learning experience

Also... With Maxi-Drives, it probably won't have stock CV joints. You need to open it up and see what is in there. It has most likely been converted to the early 110 CV joints.

I'm thinking of going with these.....

http://www.complete4x4.com.au/county...and-rover.html

Or any suggestions on the best place to buy parts around here? (Melbourne northern suburbs)