Thread: Joining multiple cables.

Depends on the application and location a bit but I like this type: CABLE JOINERS TO SUIT 8B&S CABLE 8mm hole battery cable 12v wiring 4x4 E55-0380 | eBay

Soldered with heatshrink over the top

David

What i need is more for a Y shape cable arrangement so joining 3 pairs of cable, for just 2 i would use a screw terminal strip but 2 x 6mm wont fit.
Not sure if these will work as it says for solid conductors up to 4mmsq.

3 Way Red WAGO PUSH WIRE Connector | Jaycar Electronics

Connectors are all good but you cant beat soldering together. If your running 6mm i assume you are running reasonable current. Crimp and screw type connectors can invite corrosion and faulty joins . Tin your three cables separately, place 2 cables one side and the third onbthe other.then use one strand of wire and wrap it tightly around the three .then just heat the join , insulate. Done

Jaycar do a gold terminal block which takes 1x4 SWG input cable and up to 4 x8SWG terminals.
You don't have to use the input just some of the outputs.
Gold Power Distribution Block - 1 in 4 out | Jaycar Electronics
I have had one for the past 5 years to distribute power around the back of the car.
I reckon it is neat and gives expansion room.

Regards Philip A

Originally Posted by PhilipA

Jaycar do a gold terminal block which takes 1x4 SWG input cable and up to 4 x8SWG terminals.
You don't have to use the input just some of the outputs.
Gold Power Distribution Block - 1 in 4 out | Jaycar Electronics
I have had one for the past 5 years to distribute power around the back of the car.
I reckon it is neat and gives expansion room.

Regards Philip A

Perfect, thanks Philip. I did look thru the jaycar site but didn't come across them.

When i had to join 3 cables i used this type: KnightsBridge 3 Core IP68 3 Way Waterproof Cable Joint | Electrical World