Reply With QuoteSpeedi-sleeve from a bearing joint. Take it in and get them to measure, needs to be precise.
Also fill the groove before fitting the sleeve with an epoxy metallic after degreasing, should last for yonks using a stock size seal.
DL
Wizard
My RRC v8 front main seal was leaking a lot so pulled it to put in a new seal
But there is a quite a worn lip on the shaft of the balancer - see below
Any suggestion short of a new one to ensure it seals?
Anyone got a good second hand one by any chance?
IMG_0686.jpgIMG_0688.jpg
89 Orange Rangie UTE - our play thing - sadly now sold
75 Rangie/Series/Hybrid/LS3 - Bumblebee with a sting!!!!
2018 RRS - The new touring vehicle - replaces 2012 RRS
ForumSage
Speedi-sleeve from a bearing joint. Take it in and get them to measure, needs to be precise.
Also fill the groove before fitting the sleeve with an epoxy metallic after degreasing, should last for yonks using a stock size seal.
DL
Wizard
Found a post about the speedi sleves so was going to look at that tomorrow
thanks for tip re filling groove
89 Orange Rangie UTE - our play thing - sadly now sold
75 Rangie/Series/Hybrid/LS3 - Bumblebee with a sting!!!!
2018 RRS - The new touring vehicle - replaces 2012 RRS
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks