Page 4 of 4 FirstFirst ... 234
Results 31 to 39 of 39

Thread: Trying to find a miss in 96 Discovery 3.9

  1. #31
    Join Date
    Jan 1970
    Location
    Adelaide Hills. South Australia
    Posts
    13,349
    Total Downloaded
    0
    Update.


    Cannot get a resistance reading through the sensor. I am using a digital meter but it has been suggested it's the wrong type.

    Maybe I have fried it once & for all??????

  2. #32
    Join Date
    Jan 1970
    Location
    Adelaide Hills. South Australia
    Posts
    13,349
    Total Downloaded
    0
    Can anyone help with the P/N for the 'Engine Coolant Temperature Sensor' for the 3.9 V8 please?

  3. #33
    Join Date
    Jan 1970
    Location
    Avoca Beach
    Posts
    14,150
    Total Downloaded
    0
    Cooper has invoiced the one I bought as ETC8496 sender W/temp ECU at $27.89 plus GST.
    Regard s Philip A

  4. #34
    Join Date
    Jan 1970
    Location
    Adelaide Hills. South Australia
    Posts
    13,349
    Total Downloaded
    0
    Thanks Philip.


    What was your problem then, & did it fix it?
    Last edited by 4bee; 28th July 2006 at 08:45 PM.

  5. #35
    Join Date
    Jan 1970
    Location
    SYDNEY -in the shire.....
    Posts
    8,196
    Total Downloaded
    0
    your run into town may have given the engine a bit of a clean out.....
    if you do short trips they clog up with carbon.....

  6. #36
    Join Date
    Jan 1970
    Location
    Adelaide Hills. South Australia
    Posts
    13,349
    Total Downloaded
    0
    Hhhmmmmm, how so, zook? The sensor is in the coolant circuit & not in any contact with carbon.

  7. #37
    Join Date
    Jan 1970
    Location
    Avoca Beach
    Posts
    14,150
    Total Downloaded
    0
    I didn't have a problem. I fitted new sensors to the Thor manifold that I put on the car. Just to be sure that any problems that arose during the install were not caused by faulty sensors.

    You know , through all of this , I still do not have a clear idea of under what circumstances that your car plays up. If you are just driving along at 80Kmh and it starts to miss, drops out, then the odds are your TPS has died. Also , tip in after going down a hill and resuming progress will be jerky, as will taking off from a stop.
    The TPS is the only "wear" item in a 3.9 injection, in that its a variable resistor "volume control" basically, with a contact that rubs along a resistance track.
    Its pretty expensive so you should check it first. The way to check it is to put a multimeter " on resistance if off, volts if on" across the signal wires and see that you get a smooth transition eg increase in volts or reduction in ohms with no backtracking or dropouts. Most problems of drop out will be just after rest, ie idle.

    Regards Philip A

  8. #38
    Join Date
    Jan 1970
    Location
    Adelaide Hills. South Australia
    Posts
    13,349
    Total Downloaded
    0
    Thanks Philip. It is open circuit at all temps. When it was hot yesterday & cold 1st thing this morning.

    I feel it is tied in with the crap intermittent idling (usually at traffic lights) which I have experienced over some years & have mostly 'blamed' the Idle Air Control Valve & Base Idle adjustment, but could not see how this could 'unadjust' itself. The IAC has recently been replaced with a new one.

    http://www.kemparts.com/scripts/140.asp

    It's better, but still has it's moments so after reading some of these posts & browsing the web, I checked the continuity of the TPS/ECT & found it lacking, to say the least. There were moments when I 'thought' I had readings, but now deffo not. Maybe my intermittent problem has now become permanent?
    Last edited by 4bee; 29th July 2006 at 04:29 PM.

  9. #39
    Join Date
    Jan 1970
    Location
    Riverstone, NSW
    Posts
    26
    Total Downloaded
    0
    Thanks for all the tips, I have decided i will take the risk and drive it to vic and then find the problem there, as i have alot more contacts there. goes good on long runs so i think it will be fine, maybe use a bit of extra juice if anything. Again, thanks for all the help to all.

Page 4 of 4 FirstFirst ... 234

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!