Thread: LT95 Intermediate shaft

Originally Posted by 6.5rangie

Its been taper rollered already, but will check em over

If it's had the taper roller conversion, it will be different to the stock shaft with needle bearings, which the above replies refer to.

AFAIK, the tapered rollers only take the place of the end bearings and shims.
The caged needle rollers must still be inside each gear,and wear in the gear causes the cages of the rollers to destruct, and then the bits block up the drilling in the middle of the shaft, so the oil that drains into the shaft via the v shaped drain in the case get blocked and no oil to the shaft bearings.
regards Philip A