Thread: S3 Chassis ?

Can't help with that one

Just measured the Stage 1 and it was 125-130mm not sure if they are different??
Hope this helps

Duane

G'day Lorover

what do you need it for ?? to calculate ground clearance.

cheers

I need the measurement to work out how much i have to cut off the bottom of the chassis so the sill panel will sit flat on the ground my LR is V8 2wd and air bagged so i guess its still classed as ground clearance.

Jake, if it is any help, I just went out to the shed and measured my S3 109. She measures exactly 5 inch or 125 mm from sills to chassis bottom. This was measured at the rear of the fuel tanks both sides. The floor is some 150 mm above the chassis rails.

Shorty.

Thanks Shorty that sounds a bit better than 60mm was that from the under side of the sill or top and i thought the floor sat on the chassis

Used an engineers sliding square from the very bottom edge of the sill. I held the rule end, against the sill, and slid the square up until it touched the bottom of the chassis rail. If your body sits on the chassis rails, maybe I have a lift kit under the old girl. But, it looks standard, with the body bolted to riser plates attached to the chassis. Maybe JDNSW, or good old Unca Ho can help there. I'm new to the Landy, having owned my S3 for only 3 months. Glad to help anywhere I can.

Shorty.

Thanks Shorty i will cut 125mm off the bottom and put it back in the top and if thats not enough i will have to body drop the old girl didnt want to but my fault for not measurng twice unless i can get to a LR before the plasma cutter comes out . Thanks Jake