Thread: Viscous

I made a spanner out of a piece of 50mm wide flat bar. To stop the pulley turning, a Stilson/monkey/pipe wrench hooked over the pulley (90deg from the way you would expect to use it) & a small piece of timber to protect the pulley against the jaws.

Good luck

Originally Posted by PhilipA

I can assure you that a 3.9 with V belts is LH thread.
Looking from the front of the car , you hit a large spanner with a lump hammer in a clockwise direction towards the passenger side.
So if its v belts hit that way and it should loosen
Regards Philip A

Ahh but mine does not have a V belt but a serpentine belt