Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: Auto trans temp switch RR vs D2TD5

  1. 26th September 2008, 01:31 PM #11
    goldey's Avatar
    goldey
    goldey is offline Master Supporter
    Join Date
    Apr 2007
    Location
    Newcastle NSW
    Posts
    362
    Total Downloaded
    0
    Gents

    Just resurrecting an old thread as a search revealed somebody else having had similar troubles to myself.

    Just wondering whether there was an outcome of the operation of the surface mount temperature "switch"? My hope is it works like a normally open, then reaches its preset temp and closes to make the lamp on the dash light up. If it is a varistor, then I'll have some more work to do and that goes against my laziness grain........

    Cheers
    Goldey
    Just arrived: 2012 D4 3.0 HSE, the journey begins again ;-).
    Gone: 98 Disco 300tdi Auto, and some extras
    Reply With Quote Reply With Quote
  2. 26th September 2008, 03:53 PM #12
    PhilipA
    PhilipA is offline Swaggie Subscriber
    Join Date
    Jan 1970
    Location
    Avoca Beach
    Posts
    14,152
    Total Downloaded
    0
    Its probably no help but in a RRC and probably D1 it is a simple on /off.
    Mine came on after a 70CM water crossing, so I pulled the wires ( after burning my arm reaching down between the rad and motor to dry the terminals.)
    This didn't fix it, so I left the wires pulled. I tested it again once home and Lo and behold no resistance.
    Now does anyone know if the RRC switch ( which is in the cooler line behind the LH side of the Rad) is dry or wet.
    Seeing it is working OK now I will leave sleeping dogs, but you never know.
    regards Philip A
    Reply With Quote Reply With Quote
  3. 31st July 2010, 07:17 PM #13
    Hamish71 Guest

    Reviving Old Thread

    Guys, I have fitted the RRC oil cooler to my D2A, and have the same problem. My Trans oil temp light is on. I know its an external temp sender, and have no issues with removing/replacing it....but it should work fine just connecting it straight into the existing harness, shouldnt it? If so, then I probably have a faulty sender and will replace it with a new one.

    Thanks in advance.
    Reply With Quote Reply With Quote
Page 2 of 2 FirstFirst 12
« recovery points on d1 | Another TC ABS light problem »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!