can you replace the joint by its selve or is it a whole arm replacement?
how does one go about removing the pitman arm at home......?
if you dont have one of them ten tonne hydraulic pullers.......
how much? and is it a pain in the arse?
1995 Defender 110 300TDI :D
1954 86" Series 1 Automatic :eek:
Ex '66 109" flat deck, '82 109" 3 door, '89 110 CSW V8, '74 Range Rover, '66 88" soft top, '78 88" soft top, '95 Disco ES V8, '88 Surf, '90 Surf, '84 V8 Surf, '91 Vitara.
Ron B.
VK2OTC
2003 L322 Range Rover Vogue 4.4 V8 Auto
2007 Yamaha XJR1300
Previous: 1983, 1986 RRC; 1995, 1996 P38A; 1995 Disco1; 1984 V8 County 110; Series IIA
RIP Bucko - Riding on Forever
I seem to recall a thread & images on here recently re doing it in situ.
I haven't searched & it may have also been some other forum. ??????
the joint itself is available as a kit. Theres various ways with removing the outer of the bush (pressed in the arm) my favourite is a die grinder or hacksaw to cut through it very carefully then it falls out. Also dont even try to remove the arm from the steering box.
Andy.
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks