Thread: D110 - Aftermarket front seats

Grizzley has fitted some from memory.......it would be good to make them hinge so you could still access under the seats

no chance, you have to make a new frame

any tips Tomby?

My old County had Honda Accord seats fitted by the previous owner. The seat rails hinged at the back so you could access the underseat compartments.

The mod was uncomplianced when I bought the vehicle but I had no trouble getting a compliance plate.

Originally Posted by isuzu110

My old County had Honda Accord seats fitted by the previous owner. The seat rails hinged at the back so you could access the underseat compartments.

The mod was uncomplianced when I bought the vehicle but I had no trouble getting a compliance plate.

Any pix?

I have some from Exmoor Trim in the UK that use the same bolts holes as original, though as Weeds rightly points out they would be much better if they hinged somehow so I could still get to the compartments underneath the seats easily.

Clarkie changed his passenger seat for a bucket type seat in his old 110. He might have some pointers.

What about some sort of split pin arrangement so you can lift the seat out for access (much like sports cars to remove casualties).

Also, to make life easier & more comfortable, stick a couple of lengths of 20mm box section between the rails & seat box. That way, you should raise the rails high enough to let the rails slide over the lip on the bulkhead & give you better leg room.

M

Yep i did it....
but the rails are fixed and its not complianced....

Steve