Then, typically, they got confused and put a silly car body on it. :p
Printable View
Then, typically, they got confused and put a silly car body on it. :p
so continuing along, this work was all done before my VIC 4WD show trip and worked well:
I used a Hippo liner kit (about $100) and rollered it onto the flat surfaces after flattening off the paint
https://www.aulro.com/afvb/images/im...2008/02/77.jpg
Painted this panel off the car and Sikaflexed all the edges before screwing it all down and cleaned up any overfill:
https://www.aulro.com/afvb/images/im...2008/02/78.jpg
https://www.aulro.com/afvb/images/im...2008/02/79.jpg
Then using the same Form Shield I started cutting out to cover all the remaining panels, putting the Ali side to the heat sources:
https://www.aulro.com/afvb/images/im...2008/02/80.jpg
https://www.aulro.com/afvb/images/im...2008/02/81.jpg
Put the original carpet back over the Form Shield - again using Contact adhesive on both sides:
https://www.aulro.com/afvb/images/im...2008/02/82.jpg
Cut some Form Shield the same side as the original rubber mat and put it under the mat:
https://www.aulro.com/afvb/images/im...2008/02/83.jpg
Form Shield cut out for the rear cargo area:
https://www.aulro.com/afvb/images/im...2008/02/84.jpg
Original mat went back in over the top:
https://www.aulro.com/afvb/images/im...2008/02/75.jpg
Cut out some Form Shield to cover the seat boxes:
https://www.aulro.com/afvb/images/im...2008/02/85.jpg
https://www.aulro.com/afvb/images/im...2008/02/86.jpg
https://www.aulro.com/afvb/images/im...2008/02/76.jpg
Fitted all the trim panels back in:
https://www.aulro.com/afvb/images/im...2008/02/87.jpg
https://www.aulro.com/afvb/images/im...2008/02/88.jpg
I have a false floor in place of the rear seats - this also got a coat of Hippo liner:
https://www.aulro.com/afvb/images/im...2008/02/89.jpg
https://www.aulro.com/afvb/images/im...2008/02/90.jpg
Bored yet?
LRH
Bored yet?
HELL YES!......I just de-carpeted and de-glued the 110.:D
Now it feels even more like a Land Rover!;) Just how I like it.:)
Glad your enjoying it Mick :D
LRH
I have yet to do any work on the front floor panels and firewall - will be done after Easter, once I have sorted a few issues out :D
LRH
Get back to work on the 100 inch Defender you slacker!:D:DQuote:
Originally Posted by LRHybrid100
Good stuff LRH !!!
Good job, LRH!
Can you please break down the project cost, ie amount of materials and costs?
Thanks,
Ruslan
So far I recon:Quote:
Originally Posted by Ruslan
10m Form Shield - $250
1L Contact adhesive - $60
2 Hippo Liner kits - $200
and lots of my time :D.
HTH
LRH
Have you been able to drive it yet and comment on its effectiveness?
I desparately need to reduce in cabin engine noise. Most noise seems to be coming from the transmission tunnel, possibly though the gear stick boot. Has anyone done anything to reduce noise from this opening?