When trying to improve the fuel efficiency of a Series Landrover, you need to look at how current production cars have improved fuel economy. Only a few of these can be applied to a Series Landrover.
1. Change to diesel - pretty well covered above. But apart from the cost, there is the problem of matching gearing, and finding a suitable engine.
2. Improve combustion efficiency of the petrol engine. Some room for improvement in the standard engine, but not really feasible to follow the route of modern petrol engines with an ecu holding ignition timing, mixture and boost right on the edge of preignition all the time, so you are never going to do anywhere near that.
3. Reduce aerodynamic drag - lots of scope there, but anything significant and what you end up with is not a Series any more.
4. Reduce mechanical drag - smaller diameter, narrower bearings throughout, low friction seals, disc brakes everywhere, remove unnecessary bearings such as full floating hubs. Not much of this is feasible.
5. Reduce mass. Apart from dumping the junk in the back, not a lot can be done about this once past the design stage.
Let's face it - fuel economy was not a design criterion for the original Landrover, and only modest improvements are really feasible. The only really practical one is conversion to diesel, and unless you are doing a lot of mileage, you will never recoup the cost even of this. The other thing that can be done is LPG conversion, which will not improve the economy, but will reduce the cost.
John
John
JDNSW
1986 110 County 3.9 diesel
1970 2a 109 2.25 petrol
FWD warned me not to use a T/C conversion because the 2.25 diesel didn't have enough power to drive it up hills
Pfaf.
yes it will it just means you'll be down one gear lower han stock as the really high speed tcase more or less means that what was the final 4th gear ratio is now achieved using 3rd gear
Ive been down to second high on a couple of hills pulling a trailer with the diesel 2.25 in a LWB so that'd be first in the case of the high speed tcase
but how often are you likely to be hauling up a long hill with a trailer on the back of a series rover?
Dave
"In a Landrover the other vehicle is your crumple zone."
For spelling call Rogets, for mechanicing call me.
Fozzy, 2.25D SIII Ex DCA Ute
TdiautoManual d1 (gave it to the Mupion)
Archaeoptersix 1990 6x6 dual cab(This things staying)
If you've benefited from one or more of my posts please remember, your taxes paid for my skill sets, I'm just trying to make sure you get your monies worth.
If you think you're in front on the deal, pay it forwards.
Once again alot of what you all say is right,but and there is a but you can put a mix of the fix's together for a good outcome.My second last series model had RR diffs,LPG and the motor was worked a bit.All of the parts including the lpg system can be bought second hand and when I done mine I was an apprentice so couldn't pay much.In the end that truck could do 100km/hr all day and it did for many years and it took me to Fraser island and through the Vic high country twice,the taller gearing never hurt it.A land rover will never be a ballistic efficient bullet but they aren't trying to be either. Pat
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks