Thread: Engine Swap - TD5 90 to .......LS1/6......?

10and a bit:1 compression, +zero deck height, awseome open heads, fantastic engine management, I pulled mine down and looked at porting heads and blueprining while it was apart.............nope, no need

Just a cam and springs, the standard valve springs are soft as butter

And they fit into a fender engine bay nice, there should be some picks on here of mine on this site somewhere when it had the gen3 sitting in it with the T700/LT95. Just got to make the rear drop truck sump clear the draglink, which it does easily if the motor is positioned back correctly.

Originally Posted by RonMcGr

It is a bit like the "enlightened" who stick GM motors into Jaguars and then wonder why the driving "balance" has gone.
.

How does putting a lightweight compact Chev. or Chrysler into a Jaguar in place the long, high, grossly overweight, and very obsolete Jaguar engine "upset the driving balance"? The US small block V8's are lighter, more compact, more powerful, sit their centre of gravity further back and lower down than that of the Jaguar engine. A proper installation needs reduced height front springs to restore the ride height because the V8's are so much lighter than the Jaguar 6. An added bonus is that front end weight is so reduced that you can if you wish disconnect the power assist from the steering system.

Originally Posted by Psimpson7

Sam,

Thanks for the reply. I will have a chat to 'my' engineer tommorow and see what his opinions are.

TD5 tuning seems to be pretty easy, but say 250bhp versus 450bhp is still a big difference! I also cant fit a larger intercooler as my high mount is so far back into the grill.

Cheers
Pete

hhmmmm i hope he says no to the LS otherwise i will cry

otherwise she'll be a gobsmacking beast

He was busy when I called earlier so we will have to wait until tommorow!!

Pete

Originally Posted by rovercare

Pffft, still an apprentice there? I also have a mate you works at Fishermans bend with GMH in the engine dyno/tear down/test bit

Yep, the early LS1 used oil and rattled, actually most of them rattle, they're built loose (aids performance and emission), but they rattle for 100's of thousands of kays,

1 use only? WTF? I mean, so when I pulled mine down, had the crank machined, new bearings etc I must have been dreaming

Don't base or spread crap from an early model, get annoyed when someone says Land rovers are crap/enreliable/leak oil?

They ARE the perfect conversion, for a rover, just a shame that the crappy ZF HP22 can;t handle the HP

No, as a matter of fact he is now a road tester/service advisor with Mercedes Benz after having done a couple of years with BMW and his time as a qualified mechanic with GMH, including being one of two people within his dealership qualified to do the Gen 3 rebuilds.

When I refer to single use I mean that the bores cannot be machined, so if there is damage to the bore due to piston slap etc then it's a replacement job.

Right,

Spoken to an engineer, and he has provisionally said.......

a maximum of 5800cc



(few conditions but looks promising)

Will update a bit more lately. my laptop has failed tho so I am borrowing a colleagues) not much access at the moment

Pete

gggrrrrrrrrhhhh!!!!!!! Wat the...............

doh, wish i spoke to your engineer!!!!

dam, well pete now you have no choice bu to do it

hey he may let me and a mate supercharge our 4.4 & 4.6's then? maybe we can keep up with you then

keep us posted bud.