Results 1 to 3 of 3

Thread: MSD 6AL ignition module

  1. 19th December 2008, 10:15 AM #1
    lambrover's Avatar
    lambrover
    lambrover is offline Wizard
    Join Date
    Jan 2008
    Location
    Sydney, West
    Posts
    1,241
    Total Downloaded
    0

    MSD 6AL ignition module

    has any one got any experiance with this product or similar that is readily available. I am thinking off putting one on my v8 county.
    Reply With Quote Reply With Quote
  2. 19th December 2008, 10:35 AM #2
    2door grover Guest
    I had one in a stroked 308 a few years ago, never ran right in the heat. Great when temp was below 30 deg but when it went above that it missed all the time, ended up getting rid of it and no more problems when hot. I don't know why it didn't like the heat.
    Reply With Quote Reply With Quote
  3. 20th December 2008, 10:10 AM #3
    Traco
    Traco is offline Master Supporter
    Join Date
    May 2008
    Location
    Adelaide
    Posts
    399
    Total Downloaded
    0
    I've got one on my suped up 4.6 Rover SD1. Makes a noticeable difference - easier starting, better idle, more torque.

    It can be fitted to 14 CUX equipped vehicles but you have to use an adaptor I believe for the signal wire that goes from the coil to the ECU. Look on the MSD user forum, I seem to recall there's something on there about it. MSD also have a great technical assistance service for helping resolve any technical issues, just email them.

    I may eventually get round to fitting one to my Disco. Anyone know if RPIs amplifier does much the same thing?
    Reply With Quote Reply With Quote
« 14CUX diagnostics-Good news/bad news. | Info for those building camper trailers »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!