LT77 jumps out of 3rd..

**discowhite** · 17th April 2009, 08:15 AM

the LT77 in the ute is jumping out of 3rd.. its only started after i cleaned the shifter input and removed the mud and made up a new rubber cover to seal both it and the hi/lo shifter... its not an agressive jump, half a finger nail will hold it in, it only dose it when you back off but not straight away about 5sec later. it wont do it under load either.

so is there any adjustments that can be adjusted

or is it a bungee strap and find an auto?

cheers phil

**rangieman** · 17th April 2009, 10:17 AM

It might be as plain and easy as the nose on your face , Try removing your rubber gattor you made and take it for a drive

**discowhite** · 17th April 2009, 12:32 PM

Originally Posted by rangieman

It might be as plain and easy as the nose on your face , Try removing your rubber gattor you made and take it for a drive

i did think of that! just have to find the care factor

cheers phil

**TJS-70Y** · 17th April 2009, 06:10 PM

I have a ZF sitting in the garage if you want Phil. That would solve all your problems.

Thomas

**justinc** · 17th April 2009, 06:15 PM

What do you expect with a trans like that

If you want a good V8 R380, PM me....

JC

**big guy** · 17th April 2009, 08:24 PM

Its a Landy.

**discowhite** · 18th April 2009, 08:32 AM

Originally Posted by justinc

What do you expect with a trans like that

If you want a good V8 R380, PM me....

JC

bit far to drive

should have offered me an auto,,may have considered it

cheers phil

lokka · 18th April 2009, 02:41 PM

Dose it jump out of any other gear ? try it in low range going down hill using the engin to slow it and see if it jumps out it may have a worn spigot bush in the back end of the crank this will cause it to jump out of gear

**discowhite** · 18th April 2009, 04:06 PM

only 3rd, will try the low range.

cheers phil

Thread: LT77 jumps out of 3rd..

Thread Tools

LT77 jumps out of 3rd..

Bookmarks

Bookmarks

Posting Permissions