-
9th February 2010, 10:01 PM
#1
ac compressor pulley removal
Pulley seems to be held in by a large circlip. but removing this doesn't help. The hollow shaft that the pulley is mounted on has a lip on the end which stops the pulley from sliding off Seems like you have to remove the whole shaft and pulley together How do you do this?? Any help would be much appreciated.
-
10th February 2010, 11:30 PM
#2
What Compressor is it? Sounds like a York?
-
11th February 2010, 08:16 AM
#3
I don't know what brand it is. It's on a TDi 300 but could be off a RR v8. Doesn't anyone know how tto get it off??
-
11th February 2010, 10:04 AM
#4
Not sure if you have the same setup, but this could be what you are after, courtesy of inc: http://www.aulro.com/afvb/projects-t...or-pulley.html
After removing the circlip, I think I had to use a screwdriver to separate and lever the pulley off.
I don't remember any lip to the shaft though.
-
11th February 2010, 04:33 PM
#5
nice1guv Thanks a million I did a search but missed that thread. I didn't realise that the pulley came off over the lip. All done now and air con working again.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Search AULRO.com ONLY!
|
Search All the Web!
|
Bookmarks