Thread: Diff

thanks guys, monday avo's job

ok with the flange on backwards and a couple of larger guys hanging off a crowbar. plan B came into action.

Another diff is lined up ready to go but it needs stubs.
That could be a problem because I think the axel is locked to the stub.

Now a question is front hubs interchangeable with rear hubs? they look the same in the book but that means nothing

I have had the same problem, I snapped a axle and it snapped right at the end of the spline into the side gear. The little piece worked it's way into the diff center locking the side gears and spiders together and drove of one axle, as you have experianced, removing the axle is difficult due to being bent inside the housing. The diff center was stuffed as the side gears and spider gears had broken teeth

Originally Posted by lambrover

I have had the same problem, I snapped a axle and it snapped right at the end of the spline into the side gear. The little piece worked it's way into the diff center locking the side gears and spiders together and drove of one axle, as you have experianced, removing the axle is difficult due to being bent inside the housing. The diff center was stuffed as the side gears and spider gears had broken teeth

Yes that would do it, the only thing is that the axel is tight, no movement detectable at all, in and out or sideways at the flange end

Originally Posted by 85 county

Now a question is front hubs interchangeable with rear hubs? they look the same in the book but that means nothing[/FONT]

No, Disc and Drum hubs are completely different. Stubs are rear specific as well.

RRC (10-spline) stubs may be the same.

I have a pair of perentie rear hubs which I think would fit, but outlaw has claimed them (but not yet collected).

OK as suspected the axel has welded itsself to the stub. These are new county axels, ( a bit longer) but they also had a machined surface for an inner seal ( grease hubs) why on a county i don’t know. But they slid in ok and i didn’t think much about it at the time. Obviously it picked up some where and now is locked solid.
Had it in the press, only 5 tonne with enough heat to make every thing Blue, didn’t budge at all. But with a blued stub, your not going to use that again so there was no point in wasting time.

I have a couple of pics on my phone but blue tooth is not an option in our home.

New stub coming from TRS i already have seals bearings etc. which is good still gives SWMBO a day to load up for Blinman

Hmmm a grenaded sals...rare... this thread is particularly useless without pics !!!!

S

Originally Posted by roverrescue

Hmmm a grenaded sals...rare... this thread is particularly useless without pics !!!!

S

can you get a pic from your phone onto aulro ? if so pm your number