Results 1 to 7 of 7

Thread: Alternator light is on?

  1. #1
    Join Date
    May 2007
    Location
    Melbourne
    Posts
    1,532
    Total Downloaded
    0

    Alternator light is on?

    Mmmm

    Coming out of the Eastlink tunnel tonight , turned off headlights and then alternator light came on. I think it was that close?

    Anyways , pulled over , belts all on , alternator spinning around like it should , no obvious loose wiring , no special Lucas smoke comimg out of anywhere

    Got home , had dinner and then out to see what I could see.

    Facts are this;

    1. Battery at 12.7 volts engine off ( 12.24v engine on? )
    2. Alternator putting out 12.5 volts at idle
    3. With headlights on alternator putting out 12.18 V

    Someone has suggested a broken wire somewhere but the question is how the heck would you find it !!

  2. #2
    Join Date
    Jan 1970
    Location
    Deception Bay
    Posts
    232
    Total Downloaded
    0

    alternator light

    Quote Originally Posted by land864 View Post
    Mmmm

    Coming out of the Eastlink tunnel tonight , turned off headlights and then alternator light came on. I think it was that close?

    Anyways , pulled over , belts all on , alternator spinning around like it should , no obvious loose wiring , no special Lucas smoke comimg out of anywhere

    Got home , had dinner and then out to see what I could see.

    Facts are this;

    1. Battery at 12.7 volts engine off ( 12.24v engine on? )
    2. Alternator putting out 12.5 volts at idle
    3. With headlights on alternator putting out 12.18 V

    Someone has suggested a broken wire somewhere but the question is how the heck would you find it !!
    What vehicle?

  3. #3
    Join Date
    Oct 2010
    Location
    Queensland
    Posts
    147
    Total Downloaded
    0
    Check the voltage regulator and the wires connected to it. Especially the positive source which goes to the ignition. These wires tend to perish over time with heat etc increasing the resistivity and require replacing.

    I had my alternator light on the dash flicker particularly when load on the alternator varied i.e. lights on to off or a/c on to off etc.

    The voltage regulator is located on the passenger side strut tower (near to shock absorber access cover)...on a 86 county anyway.

    Failing that, you could be looking at a problem with the alternator itself.

    Hope this helps.

  4. #4
    Join Date
    Jan 1970
    Location
    Wheelers Hill, Melbourne
    Posts
    4,085
    Total Downloaded
    0
    Quote Originally Posted by Gavo View Post
    What vehicle?

    With prince of darkness, can only be the Isuzu or stage 1.

    Edit
    Whoops, just saw there's some series in there 2. Good question.

    Either way,

    A multimeter with a alligator clip should be able to find it using the circuit tester mode. You might also be able to rig up a buzzer or globe using a 12v battery to test a wire's integrity, use the wire you are testing to complete the circuit. No circuit, no worky...

  5. #5
    Join Date
    May 2007
    Location
    Melbourne
    Posts
    1,532
    Total Downloaded
    0
    Thanks Guys

    It's the Isuzu County.

    Doesn't seem to be losing any voltage.

    Had 3 starts today and sitting battery voltage is still at 12.5 approx

    Will check the reg wiring though , thanks.

  6. #6
    JDNSW's Avatar
    JDNSW is offline RoverLord Silver Subscriber
    Join Date
    Jan 1970
    Location
    Central West NSW
    Posts
    29,521
    Total Downloaded
    0
    With the alternator charging, battery should be over 12.5. I assume it has the separate regulator inside the LH guard - check this, and in particular, that the earth wire has not burnt out. If this is the case, the engine/chassis earth strap is open circuit or high resistance (it is across the LH engine mount) possibly due to oil plus loose bolts.

    Another possibility I have run across is a loose (rather than broken) fan belt.

    John
    John

    JDNSW
    1986 110 County 3.9 diesel
    1970 2a 109 2.25 petrol

  7. #7
    Join Date
    Jan 1970
    Location
    Deception Bay
    Posts
    232
    Total Downloaded
    0
    Quote Originally Posted by land864 View Post
    Thanks Guys

    It's the Isuzu County.

    Doesn't seem to be losing any voltage.

    Had 3 starts today and sitting battery voltage is still at 12.5 approx

    Will check the reg wiring though , thanks.
    Had a similar prob on a mates one.
    There was power drop through the wiring that leads to the regulator.
    There are two leads in the plug that connect to the regulator that have power to them when the conector is un plugged one is an feed from the battery and the other is from the key (only has power when the key is on).
    one of these leads only had 12.5 volts must had been the one from the key. Well anyway we ended up using the one from the key to operate a relay which we then hooked those to wire together and conected so when the key came on power direct from the battery went to both those terminals in the conector plug.
    After that didn't have the problem.
    You may want to look at the regulator I have seen one coil in the old tyye one burn out and have the same problem.
    Might be the brushes on there way out to if it flickers I have found its the brushes.

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!