I ordered a 29mm 21spline 275mm clutch disc so that I could utilise my standard flywheel and pressure plate...John is correct there will be no mistaken the correct match
Printable View
I ordered a 29mm 21spline 275mm clutch disc so that I could utilise my standard flywheel and pressure plate...John is correct there will be no mistaken the correct match
Good work AM, I have skills and workshop envy. :(:angel:
MSA-5G clutch
Isuzu P/N 8970234960
Paid $NZ184.42 plus gst approx 2007
21 spline, 28.9mm spline, 275mm OD
The Isuzu output flange I have. It's the turned flange mated to it in the picture below that I'd be interested in.Quote:
Originally Posted by Ancient Mariner
http://www.aulro.com/afvb/attachment...r-100_0187.jpg
With Grubbs solid shaft and also this flange that Dougal is referring to does the input seal of the lt230 run on the section that would have to be roughly 43mm dia ? Or have there been other ways ?
The seal runs on the raised section between the two splines I made the diam 1.500" to
suit the material on hand so a seal change is required .original od or you could press on a sleeve to suit the original seal
Auh very nice... Never even contemplated changing seals :angel:Quote:
Originally Posted by Ancient Mariner
Has anyone a gearbox that suits the 29mmx21 spline clutch plate available and able to measure the imput shaft for me.The supplier says my shaft is worn:o
but imput shafts don`t wear on the OD and there is no sign of any so not keen
to order the plate till I can get a proper measurement:confused:
Thanks AM
If you can see the machine grooves on the peaks it's not warn...sorry I do not have the box out at the moment though ...Quote:
Originally Posted by Ancient Mariner
There is no wear .044" would stand out like dogs